Put on all tappets, valves and springs marks corresponding to their location in the cylinder head so that during assembly, they do not change their original location

Removing and installing the clutch master cylinder Remove the master cylinder for replacement or repair in case of fluid leakage, incomplete clutch disengagement (may be caused by fluid leakage or...

Replacing downpipes with engines ZMZ-4025, 4061, 4026, 4063 It is more convenient to work together on a viewing ditch or a lift

To seal the joint between the flanges of the cylinder head and the intake manifold, as well as between the flanges of the throttle assembly and the intake manifold, sealing rings are installed in...

We replace the ball joint if during the check a backlash of the ball joint is found We raise the front of the car and place it on reliable supports

To remove the power steering radiator, remove the air filter, article - " Replacing the air filter "

The engine cooling system is liquid, closed type, with forced circulation of the liquid. The device of the cooling system is shown in the figure

Auxiliary units: generator, water pump, power steering pump and air conditioning compressor of the 2GR-FE engine are driven by a V-ribbed belt

When the cylinder body is open, do not press the brake pedal, otherwise the piston will pop out. Do not damage the piston boot and do not allow oil to get on the brake disc

You will need: 10" wrench, 13" wrench, flat and Phillips screwdrivers Disconnect the wire from the negative terminal of the battery.

Windshield wiper mounted under windshield trim The cleaner motor is a three-brush, two-speed, permanent magnet excitation.

The body of the car is a five-door, all-metal, welded, load-bearing structure

Signs of a throttle that is not fully closing may be increased idling speed and fuel consumption, and not fully opening - the engine does not develop full power, insufficient engine response, jerks...

Welding tailgate hinges Remove components and parts that prevent straightening, welding and painting work

Renault Logan is equipped with two independent brake systems: working and parking

Checking the operation of the vacuum booster Release the existing vacuum with the engine off by depressing the brake pedal several times at 5-second intervals

We replace pipelines if they are worn and severely bent, as well as in case of damage

According to the manufacturer's recommendation, the brake fluid should be replaced after 6 years of operation or after 90 thousand kilometers (whichever comes first)