It is recommended to change the oil in the gearboxes of the front and rear axles every 45 thousand km. But these are factory recommendations

The steering mechanism is mounted on the left side member and secured through the bracket with bolts and nuts

The driveline is designed to transmit torque from the gearbox to the transfer case and from the transfer case to the front and rear drive shafts

Change the grease in the bearings at the intervals given in the service book. If there is not enough lubrication or it is contaminated, the bearings will quickly fail

Disconnect the negative cable from the battery Discharge the coolant Remove the right mudguard and mudguard

Disconnect the negative cable from the battery Remove the following items:

If the sensor fails, the engine starts poorly, especially after a long period of inactivity. Poor throttle response, increased fuel consumption. Fault light on

Shock absorbers are used to dampen suspension vibrations Protruding from the shock absorbers, the upper parts of the rods are protected from dirt by rubber caps.

Characteristics and malfunctions of the brakes of the Kia Magentis car Technical data

Put the car on a two-post lift Make sure the vehicle springs and dampers are color-coded to match the parts

Inlet and outlet rubber hoses fit to the heater core. Fluid is taken into the radiator with the heater valve open, from the cylinder head, and drained to the engine cooling system pump.

To remove the A-pillar upper trim, the sun visor must be removed

Removing and installing the vacuum booster for Mazda 3 Remove the battery and battery tray

Exhaust gases are removed from the engine through a catolector (exhaust manifold combined with a converter), an additional converter built into the exhaust pipe, an additional and main muffler

Remove bracket Put the car on a two-post lift

When the car battery is discharged, you can start the engine from the battery of another car

Door interior design includes: power window regulator, interior handle, door speaker, harness and internal baffles

Setting the first piston cylinder to top dead center is necessary for various engine repairs